Nozzles TORO irrigation MPR for diffuser 570 Z
For Diffuser 570 Z.
The nozzles matched precipitation rates and color-coded according to the radio for quick identification are just some of the advantages offered by the nozzles of the diffuser 570 MPR Plus. Adapt to any body diffuser 570, adapter bushes or extension tube.
For Diffuser 570 Z.
Features:
- The proportional flow of irrigation ensures that all the nozzles (all the spokes and arcs) irrigated with the same rate.
- The low flow rates allow you to install more sprinklers in the same watering zone.
- The compensator pressure PCD prevents fogging, conserves water and can come pre-installed or separately.
- Easy identification of the radio by color.
- Complete selection of arcs for all of the radio options: full circle, ¾, 2⁄3, ½, 1⁄3,¼.
- Sectors of irrigation improved: improved consistency on the outside edges, eliminating scope is too long or too short.
- Exact adjustment of the radius and the flow rate (the adjustment will not be lost).
- Nozzles 1.5 m (5’) that are adjusted up to 1m (3’).
- Spray normal and special for small areas.
- Full set of arcs for nozzle radii of 3 m, 2.4 m and 1.5 m (10’, 8’ and 5’).
- Side strip 1.2 x 5.5 m (4’ x 18’), ideal for medium sized parking areas.
- 0.6 x 1.8 m (2’ x 6’) for planters small and other tight areas.
- 5 levels of trajectory.
- Filters of fine mesh that prevent the clogging of nozzles when there is little flow.
- Adjustment screw reduces the radius by up to 25% or so completely closes.
Specifications:
- Strip flow rate: 0,2-17 L/min (0,05-4,58 GPM).
- Pressure to which the performance of the nozzle to be optimal: 2 bar.
- Recommended operating pressure: 1,4-3,5 bar (20-50 psi).
- Maximum working pressure: 5.2 bar (75 psi).
Advantages
- Precipitation rates coincident
- Ensures that all the nozzles with radii common to apply water at approximately the same speed.
- Pressure compensation installed
- Prevents misting, excessive, saves water, provides flow rates accurate and can be installed or separately.
Video - Installation, and settings
![]() |
Nozzle MPR mod. 15 - BlackArcs: from 90 ° to 360 Range: 4.6 m Color: Black |
![]() |
Nozzle MPR mod. 12 - BrownArcs: from 90 ° to 360 Scope: 3.7 m Color: Brown |
![]() |
Nozzle MPR mod. 10 - BlueArcs: from 90 ° to 360 Reach: 3.0 m Color: Blue |
![]() |
Nozzle MPR mod. 8 - GreenArcs: from 90 ° to 360 Scope: 2.5 m Color: Green |
![]() |
Nozzle MPR mod. 5 - RedArcs: from 90 ° to 360 Scope: 1.5 m Color: Red |
![]() |
Nozzle MPR mod. Strip - OrangeArcs: from 90 ° to 360 Scope: pattern "strip" Color: Orange |





