Choose valves of the Series P-150 when you need to pressure regulation or low pressure.

The new plastic valves P-150 for commercial use Toro are the workhorses of the plastic valves. With a pressure of 10 bar (150-psi), then you're plastic valves can withstand the high pressures of commercial applications.

With the optional device EZReg™, regular pressure is as simple as dialing in the setting on the dial.

Specifications

• -Female thread 1 1/2" and 2" with flow regulator.

• -Flow of work of 19 - 568 l/min.

• -Working pressures of 1.4 to 10 kg/cm2.

• -Intake boot of 0.34 mpa, and maintained in 0.2 amp.

Features

• -Manufactured in nylon reinforced with fiberglass and stainless steel resistant to corrosion.

• -Pressure regulation in both automatic operation and manual.

• -Design of flow direct, for more precise control.

• -Settings in globe or angle.

• -To work at a pressure of 10 bars with flows from 20 to 568 lpm (5 to 150 GPM).

• -The water passes through a filter to remove the obstruction in the bore of the solenoid. The filter is accessible from the top.

• -Slow closure reduces the water hammer.

• -The flow regulator, adjustable flow rate and zero.

• -Diaphragm double-lip rough, in santopreno.

• -Solenoid injected in a mould with a plunger captive.

• -Precise Control of the pressure regulator, EZReg ® (factory installed or to be installed in the field) don't need to pull the solenoid.

• -The pressure can be adjusted while operating manually or electrically, under pressure.

• -No tubing external to the electric models, or models with pressure regulator.

• -Easy maintenance, without removing components.

• -Solenoid encapsulated, injected into the mold, with the core captive.

• -Solenoid in purple for recycled waters.

• -Accepts solenoids DC.

• -Sealing gasket in the plug input.

• -3 screws SS on the lid that accommodate a hex screwdriver or Phillips screwdriver.